Connecting your motherboard securely to your case’s motherboard standoffs. Slide the motherboard into position and use a screwdriver to tighten the thumbscrews located in the corner of each hole. Push the power supply back until it clips into place. Once it’s detached, pull the wire management tray towards you and slide it back into the case’s frame, where it will clip into place with a satisfying click. There are two sets of brackets at each end, so make sure to take both off before proceeding. This will reveal four additional screws that you will need to remove to detach this tray from its brackets on either end. Next, remove all of the hard drives, placing them on one side of your workspace, and slide out the wire management tray on the opposite side of your workspace. Now remove the six screws holding the five internal hard drive cage brackets and place them in a safe spot, as you’ll need them later. Prepare your case for building by removing the four screws holding down the two side panels. If you would like LED lights, then make sure to choose Yes under LED Control. These are primarily aesthetic and can be distracting while gaming, so they are not recommended if possible. Finally, you should decide if you want LED lights on your fans.To make sure there is enough airflow, we recommend using standard orientation for all three fans. You can either have them blowing air directly into the case (standard), blowing out of the case (reverse), or completely off (off). Next, you need to choose which orientations you want your fans in.For a basic setup, we will assume that you want to use a 140mm fan on the top and 2 120mm fans on the bottom of your case. The NZXT H510 supports either 120mm or 140mm fans, with the intake fan acting as an exhaust for air and one outtake fan acting as an intake for the case. The first thing that you need to do is choose the preferable fan size.What is the best configuration for NZXT h510 flow with arctic p120s/ f120s?.

Nzxt h510 airflow